Sharp AR-203E ユーザーズマニュアル

When the following indicators light up or blink on the operation panel or the following alphanumeric codes 
appear in the display, solve the problem immediately referring to both the table below and the relevant page.

Developer 

replacement required 

indicator

Steadily 

lit

Developer is required. contact your authorised 

service representative.

Toner cartridge 

replacement required 

indicator

Steadily 

lit

Replacement of Toner cartridge will be needed soon. 

Prepare a new cartridge. (AR-208T)

Blinking Toner cartridge must be replaced. Replace it with a 

new one. (AR-208T)

Misfeed indicator

Blinking

A misfeed has occurred. Remove the misfed paper 

referring to the description of "MISFEED REMOVAL".

The lower side cover may be open. If so, close it.

Maintenance 

indicator

Steadily 

lit

Service by an authorised SHARP service technician 

is required.

SPF misfeed 

indicator

Blinking

An original misfeed has occurred in the SPF. Remove 

the misfed originals referring to the description of "E: 

Power save indicator is steadily 

lit.

The unit is in the preheat mode. Press any key to 

cancel the preheat mode.

The unit is in the auto power shut-off mode. Press the 

start (

) key to cancel the auto power shut-off 

mode.

The paper tray indicator is 

blinking.

The paper tray is not installed properly. Push the tray 

into the unit securely.

–

"CH" is blinking in the display.

The toner cartridge is not installed. Check if the 

cartridge is installed. If "CH" is blinking even if a 

cartridge is installed properly, contact your SHARP 

service centre immediately.

–

"CH" is steadily lit in the display.

Side cover is open. Close the side cover securely by 

pressing the round projections near the side cover 

open button.

–

"P" is blinking in the display.

The paper tray or multi-bypass tray is empty.

Load paper.

A misfeed has occurred in the paper tray, single 

bypass or multi-bypass tray. Remove the misfed 

paper.

Paper tray is not securely installed. Push the tray in 

securely.

–

A letter and a number appear 

alternately.

The scan head locking switch is locked. Unlock the 

scan head locking switch and turn the power switch 

off/on.

A letter and a number appear 

alternately.

The unit will not function. Turn the power switch off 

and then switch it on, and if there is again an error, 

remove the power cord from the outlet, and contact 

your authorized service representative.

–

A letter and a number appear 

alternately.

The unit will not function. Turn the power switch off 

and then switch it on, or when the side cover is 

opened and then closed ; and if there is again an 

error, check whether or not you forgot to remove the 

bundling tape on the cartridge.

–