Motorola CPX8216TCPX8216T ユーザーズマニュアル
5-4
Computer Group Literature Center Web Site
Transition/Bridge Modules
5
Serial Port Interface Jumper (J8 and J9)
J8 (for serial port 3) and J9 (for serial port 4) set the serial ports to either
DTE or DCE communication. For more information about configuring the
serial port, see
DTE or DCE communication. For more information about configuring the
serial port, see
.
Figure 5-2. Serial Port Interface Jumper (J9) Settings
Connectors
for the location of the following connectors
Backplane Connectors (J3/J4/J5)
I/O signals and power are provided to the CPX750HATM from the
CPX750 through CompactPCI connectors J3 and J5. The J4 connector is
for physical alignment purposes only and has no functional pin
connections or assignments.
CPX750 through CompactPCI connectors J3 and J5. The J4 connector is
for physical alignment purposes only and has no functional pin
connections or assignments.
Connector J3 is a 95-pin AMP Z-pack 2mm hard metric type B connector.
This connector routes the I/O signals for the PMC I/O and serial channels.
The pin assignments for J3 are as follows (outer row F is assigned and used
as ground pins but is not shown in the table):
This connector routes the I/O signals for the PMC I/O and serial channels.
The pin assignments for J3 are as follows (outer row F is assigned and used
as ground pins but is not shown in the table):
Connector J4 is a 110-pin 2mm hard metric type A connector. This
connector is placed on the board for alignment purposes only. The keying
tabs on the type A connector assist with alignment of pins in the backplane
connector during insertion of the boards. No signals are connected to J4
except the row F ground pins.
connector is placed on the board for alignment purposes only. The keying
tabs on the type A connector assist with alignment of pins in the backplane
connector during insertion of the boards. No signals are connected to J4
except the row F ground pins.
Connector J5 is a 110-pin AMP Z-pack 2mm hard metric type B connector.
This connector routes the I/O signals for the IDE (secondary port), the
keyboard, the mouse, the two USB ports, and the printer ports. The pin
This connector routes the I/O signals for the IDE (secondary port), the
keyboard, the mouse, the two USB ports, and the printer ports. The pin
11650 9610
1
2
3
1
2
3
DCE
DTE