ColorVision c2630 ユーザーズマニュアル
4-1
Section 4
BASIC OPERATION
1
Warm-up
Turn the power switch ON ( | ). At the end of warm-up, “Ready to
copy.” will be displayed in the message area of the touch panel.
copy.” will be displayed in the message area of the touch panel.
NOTE
If a Memory Copy Board is installed in your copier, and
you set the original that you want to copy and press the
[Start] key while the copier is still warming up, copying
will begin as soon as warm-up is completed.
you set the original that you want to copy and press the
[Start] key while the copier is still warming up, copying
will begin as soon as warm-up is completed.
2
Setting an original
Open the original cover and set the original that you want to copy
face-down on the platen. Be sure to align originals with the upper
left corner of the platen (towards the left-rear portion of the copier).
face-down on the platen. Be sure to align originals with the upper
left corner of the platen (towards the left-rear portion of the copier).
NOTE
See “Setting originals in the Document Processor”
on page 8-2 for instructions on how to set originals in your
Document Processor (option).
on page 8-2 for instructions on how to set originals in your
Document Processor (option).
3
Selecting the color mode
Press the [Full Color] key, the [A.C.S.] key or the [Black & White]
key, as desired, to light the lamp in that key.
Full color copy mode: Press the [Full Color] key to light the lamp
in that key. Select this mode when you want to make full color
copies.
Auto Color Selection mode: Press the [A.C.S.] key to light the
lamp in that key. The copier will automatically detect the
difference between color and monochrome (B/W) originals, and will
select the full color copy mode for color originals and the black and
white copy mode for monochrome (B/W) originals.
Black and white copy mode: Press the [Black & White] key to
light the lamp in that key. Select this mode when you want to make
black and white copies.
key, as desired, to light the lamp in that key.
Full color copy mode: Press the [Full Color] key to light the lamp
in that key. Select this mode when you want to make full color
copies.
Auto Color Selection mode: Press the [A.C.S.] key to light the
lamp in that key. The copier will automatically detect the
difference between color and monochrome (B/W) originals, and will
select the full color copy mode for color originals and the black and
white copy mode for monochrome (B/W) originals.
Black and white copy mode: Press the [Black & White] key to
light the lamp in that key. Select this mode when you want to make
black and white copies.
NOTES
• If the mono-color mode is selected, the currently
selected color for that mode will be displayed: “CYAN”,
“MAGENTA”, “YELLOW”, “RED”, “GREEN” or
“BLUE”. (See “Mono-color mode” on page 5-6.)
“MAGENTA”, “YELLOW”, “RED”, “GREEN” or
“BLUE”. (See “Mono-color mode” on page 5-6.)
• It is also possible for you to make other adjustments to
color copying.
Adjusting the color balance (Page 5-1.)
Adjusting the color hue (Page 5-3.)
One-touch image quality adjustment (Page 5-5.)
Gloss mode ON/OFF (Page 5-7.)
Adjusting the color balance (Page 5-1.)
Adjusting the color hue (Page 5-3.)
One-touch image quality adjustment (Page 5-5.)
Gloss mode ON/OFF (Page 5-7.)
Basic copying procedure