ColorVision c2630 ユーザーズマニュアル
Section 6 OTHER CONVENIENT FUNCTIONS
6-5
Interrupt copying is useful if, during one copy job, you want to copy
other originals at different settings. Once the rush job is completed,
the interrupted copy job can be resumed at the same settings as
before.
other originals at different settings. Once the rush job is completed,
the interrupted copy job can be resumed at the same settings as
before.
1
Press the [Interrupt] key to light the lamp in the
[Interrupt] key.
“Interrupt mode OK” will be displayed.
[Interrupt] key.
“Interrupt mode OK” will be displayed.
2
Remove the originals that were currently being copied and
put them aside.
put them aside.
3
Set the new originals and perform the desired copy
procedure.
procedure.
4
When copying is completed, press the [Interrupt] key once
again, and replace the newly copied originals with the ones
removed before.
Then, press the [Start] key. The interrupted copy job will be
resumed.
again, and replace the newly copied originals with the ones
removed before.
Then, press the [Start] key. The interrupted copy job will be
resumed.
NOTE
When the Memory Copy Board is installed on your copier,
or when you are using a duplex copier, copy will be
resumed using the data that was scanned into the hard
disk. There is no need to rescan the same original data.
or when you are using a duplex copier, copy will be
resumed using the data that was scanned into the hard
disk. There is no need to rescan the same original data.
Interrupt copying