Viewsonic VS14693 ユーザーガイド

8

The remote control is powered by two 1.5V AAA batteries.
To install or replace batteries: 

 

 

1.  Press and then slide the cover to open it. 
2.  Align the batteries according to the (+) and (–) indications 

inside the battery compartment. 

3.  Replace the cover. 

The incorrect use of batteries can result in leaks or bursting. Be 

sure to follow these instructions:
•  Place “AAA” batteries matching the (+) and (–) signs on each 

battery to the (+) and (–) signs of the battery compartment.

•  Do not mix battery types.
•  Do not combine new batteries with used ones. It causes 

shorter life or leakage of batteries.

•  Remove the dead batteries immediately to prevent them 

from liquid leaking in the battery compartment. Don’t touch 

exposed battery acid, it cause damage to your skin.

NOTE:   If you do not intend to use the remote control for a long 

period, remove the batteries.

•  Do not subject to strong shock.
•  Do not allow water or other liquid to splash the remote 

control. If the remote control gets wet, wipe it dry 

immediately.

•  Avoid exposure to heat and steam.
•  Other than to install the batteries, do not open the remote 

control.

Point the top of the remote control toward the display’s remote 

control sensor when pressing a button.
Use the remote control within a distance of less than 10m/33ft 

from the display’s sensor, and a horizontal and vertical angle of 

less than 30 degrees.
NOTE:   The remote control may not function properly when the 

remote control sensor on the display is under direct 

sunlight or strong illumination, or when there is an 

obstacle in the path of signal transmission.

30

30

CDP3235/CDP4235/CDP4635 series

 

30

30

CDX5550-L