Viewsonic VS13510 ユーザーズマニュアル

The following table shows the combination of signal inputs under which the “PIP” and “POP” modes function. These modes do not 

function, however, when the screen size is “CUSTOM” or “REAL”. 

±

±

±

±

{

{

±

±

±

±

{

{

 {: Supported 

±

±

±

±

{

{

±: Not supported 

±

±

±

±

{

{

{

{

{

{

±

±

{

{

{

{

±

±

Press the “PIP ON/OFF” buttons on the remote control to change between “PIP”, “POP” and “SIDE BY 
SIDE” mode as shown in the diagram below.

PIP POP 

SIDE BY SIDE 

ASPECT 

SIDE BY SIDE FULL 

OFF

  “PIP”, “POP” mode resolution (Reference) 

PIP SIZE 

SMALL 

MIDDLE 

LARGE 

: 450 dots X 338 dots 

: 675 dots X 450 dots 

: 900 dots X 675 dots 

POP SIZE 

: 450 dots X 338 dots

By connecting multiple monitors using RS232C cables, you can control any one monitor or all the monitors by one remote controller. 

1.    Assign arbitrary ID number to each of multi-connected monitors using MONITOR ID. ID numbers 1 to 26 

are selectable. 

It is recommended to assign sequential ID numbers from 1 and up. 

2.    The remote control mode of the first monitor is set to PRIMARY and those of the other monitors are set to 

SECONDARY.

3.    When you direct the remote controller at the remote control signal sensor of the PRIMARY monitor and press the DISPLAY 

button on the remote controller, the ID selection OSD appears at the upper left of the screen. 

ID number of the currently viewed monitor 

Select the ID number of the monitor you want to control using the 

ُ/ٙ button 

on the remote controller. 
The ID of the monitor you want to control is displayed at the upper left of its screen.   
By selecting ALL, you can control all the multi-connected monitors. 

4.    Direct the remote controller at the remote control signal sensor of the PRIMARY monitor. OSD 

appears on the monitor having the ID number you selected. 

When the ID selection OSD is being displayed on the PRIMARY monitor, press the DISPLAY button on the remote controller again to 

cancel the ID selection OSD and then control the monitor you selected. 

If you set the remote control mode wrongly and remote control operation becomes unavailable, press MENU button on the control panel of 

the monitor to display the OSD screen and change the remote control mode using ADVANCED OPTION. By pressing 

and holding down the DISPLAY button on the remote control for 5 seconds or longer, the remote control mode is initialized to 

NORMAL. 

CD4233

39