Infocus INF55WIN8 ユーザーズマニュアル

Page 9

INF55WIN8 Hardware Guide

1) 

If you have not already done so, carefully place your monitor face-down on a clean, cushioned surface with the top edge hang-
ing off of the cushioned surface by 4-5” (10-13cm). Do NOT place the monitor on its back. 

2) 

Remove the monitor feet slot covers with a Philips screwdriver. Discard or save for future use.

3) 

Slide the feet into the slots provided (the longer side of the feet point toward the front of the monitor), then secure the legs to 
the monitor with the provided screws.

 

4) 

Using the handles on the back of the monitor, lift the monitor upright.

For additional accessory options, such as stands, carts and wall mounts, see the InFocus website (www.infocus.com/store) or your 
local dealer.

•  This monitor is very heavy and should be moved by at least two individuals.
•  Three screw holes have been included in each leg to allow you to adjust the height of the monitor. Regardless of the height, you 

must use two of the screw holes in each leg. Failure to do so may result in the screw begin sheared off and the leg collapsing.

•  When mounting the monitor to a wall, metric 8 (12mm) screws must be used. In addition, the mounting interface should comply 

with the UL1678 standard in North America. The mounting means should be strong enough to bear the weight of the monitor 
(approximately 114.2 lbs/51.8 kg without the stand).

Secure the legs here unless a sound bar is 

being attached.

(The spacers are not used.)

Use the included spacers and 
secure the legs here, when 
attaching a sound bar.