JVC 0204MKH-MW-VP ユーザーズマニュアル
14
Basic Operations
Daily Operations
1
Turn on the main power.
Set POWER on the back of the Monitor to “| (on)”.
The POWER lamp on the upper left of the front panel
lights orange.
• If you have turned off the Monitor not by using
The POWER lamp on the upper left of the front panel
lights orange.
• If you have turned off the Monitor not by using
POWER ON on the remote control (or
on the front
panel), but by using the POWER switch, setting the
power switch to “| (on)” lights the power lamp green
and turns the Monitor on.
power switch to “| (on)” lights the power lamp green
and turns the Monitor on.
2
Turn on the power.
Press POWER ON on the remote control to turn the power
on.
The POWER lamp lights green.
• You can also use the
on.
The POWER lamp lights green.
• You can also use the
on the front panel (lower
right) to turn on the Monitor.
3
Select an input.
Select the desired input by pressing INPUT SELECT
(VIDEO A, VIDEO B, COMPO./(RGB B) and RGB A).
• You can also select the input by pressing INPUT on the
(VIDEO A, VIDEO B, COMPO./(RGB B) and RGB A).
• You can also select the input by pressing INPUT on the
Monitor. Each time you press the button, the input
mode changes in sequence.
mode changes in sequence.
Note:
• To select “COMPONENT” or “RGB B,” you need to set the
• To select “COMPONENT” or “RGB B,” you need to set the
“RGB/COMPO.” setting correctly.
4
Adjust the volume.
Note:
• While no menu is displayed, you can adjust the volume by
• While no menu is displayed, you can adjust the volume by
pressing
2 / 3 on the Monitor.
To turn off the volume immediately
Press MUTING.
“MUTING ON” is displayed, and the sound goes out.
Pressing the button again resumes the previous volume level.
“MUTING ON” is displayed, and the sound goes out.
Pressing the button again resumes the previous volume level.
To make the screen indication appear
Press DISPLAY
.
The types of input and signal are indicated on the screen for
about 3 seconds.
You can also make the screen indication appear using menus
(page 24).
about 3 seconds.
You can also make the screen indication appear using menus
(page 24).
VIDEO A
VIDEO B
RGB A
COMPONENT or RGB B
Rear View
V I D E O A
N T S C
N T S C
Input selected
Input video signal
Ex. When selecting “VIDEO A” input
: 1 0
V O L U M E
+
–
1
POWER
VIDEO
DISPLAY
OFF
POWER
RM–C579 REMOTE CONTROL UNIT
ON
ASPECT
MUTING
MENU/EXIT
VOLUME
A
COMPO.
/(RGB B)
B
RGB A
INPUT SELECT
4
3
2
MUTING
DISPLAY
EN_14_23_GM_V42C.p65
04.1.14, 1:22 PM
14