Infrasonic BLOW5D ユーザーズマニュアル

 

 

 
 

 
 

BLOW5/BLOW5D User’s Manual 

 

11

 

4. CONNECTION 

ƒ All connections should be made, And faders, volumes, sensitivity and other controls are at minimum levels. 

ƒ Before powering up the BLOW5 speakers, all other equipment should be turned on first. 

ƒ Please make sure that the unit is plugged into the correct voltage.

ƒ The power switch is located on the rear panel.   

ƒ Turn on the power to the BLOW5. 

ƒ The unit is equipped with a protection circuit, an interval of a few seconds is required before the unit will 

operate normally. 

ƒ Connect the male side of an XLR balanced cable to the XLR input or TRS balanced (or unbalanced) cable 

to the TRS input of the rear panel.   

ƒ Input Select Switch should be set to analog input.   

ƒ Refer to the following diagram. 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 
 
 
 
 
 

< Connecting of Analog XLR balanced cable >

 

< Connecting of TRS Analog balanced/unbalanced cable >

 

TRS balanced cable

 

TRS unbalanced cable

 

XLR balanced cable