IBM 201 ユーザーズマニュアル
Table 10. Intel PRO 1000 XT Server adapter troubleshooting chart (continued)
Adapter problem
Suggested Action
For Windows 2000 or XP:
Unable to remove PROSet in
SAFE mode
Unable to remove PROSet in
SAFE mode
If the computer hangs (blue screen) after configuring network adapters with
PROSet, try the following:
PROSet, try the following:
v
Start Windows in Safe mode
v
Go to the Device Manger, and disable the network adapters and teams.
v
Restart the computer.
v
Windows should be operating normally if the problem was caused by the disabled
adapters.
adapters.
To uninstall PROSet, perform the following steps:
v
Start Windows in Safe mode.
v
Use the Device Manager to disable all teaming instances.
v
Restart the computer in Normal mode.
v
Using PROSet, remove all teams and VLANs shown.
v
Go to the Control Panel, select Add/Remove Programs.
v
Uninstall PROSet.
Indicator lights
The adapter has the following indicator lights:
Label
Indication
Meaning
ACT/LNK
Green on
The adapter is connected to a valid link partner.
Green flashing
Data activity
Off
No link.
v
If the LINK light is not on, check all
connections at the adapter and link partner.
Make sure the link partner matches the link
partner or is set to auto-negotiate, and the
driver is loaded. (The link indicator will not be
active until the driver is loaded.)
connections at the adapter and link partner.
Make sure the link partner matches the link
partner or is set to auto-negotiate, and the
driver is loaded. (The link indicator will not be
active until the driver is loaded.)
v
Make sure the cable is installed properly. The
network cable must be securely attached at all
connections. If the cable is attached but the
problem persists, try a different cable.
– For copper connections, make sure the
network cable must be securely attached at all
connections. If the cable is attached but the
problem persists, try a different cable.
– For copper connections, make sure the
cable is a 4-pair Category-5 or better.
– For fiber connections, make sure the cable
is SX mode. Check to see if the Rx and Tx
port connectors have been reversed.
port connectors have been reversed.
v
Yellow flashing
Identity. Use the Identify Adapter button in
PROSet II to control blinking. See PROSet II
Help for more information.
PROSet II to control blinking. See PROSet II
Help for more information.
10 = OFF
Off
10 MBPS
100 = GRN
Green
100 MBPS
1000 = YLW
Yellow
1000 MBPS
Troubleshooting the Alacritech Quad-Port 10/100 Ethernet adapter
Table 11 on page 70 displays the LED definitions for the Alacritech Quad-Port
10/100 Ethernet adapter LED definitions
10/100 Ethernet adapter LED definitions
Chapter 7. Troubleshooting
69