Atlantis Land A05-15AM-E01 ユーザーズマニュアル
ENGLISH
A05-15AM-E01_X02
7 - 44
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected. - Consult the dealer or an experienced radio/TV technician for help.
connected. - Consult the dealer or an experienced radio/TV technician for help.
2 Installing the Monitor
2.1 Unpacking
Open the shipping cartons and check the contents.
If any items are missing or damaged, contact your dealer immediately.
The package should include the following items:
If any items are missing or damaged, contact your dealer immediately.
The package should include the following items:
•
TFT color monitor
• User's
guide
• Power
cord
• Signal
cable
•
DC power adapter
• Audio
cable
2.2 Making
Connections
CAUTION:
•
Ensure that the power to the monitor, the computer, and other connected devices is off
before making any connections.
before making any connections.
•
When unplugging the connector, always hold the plug. Never pull on the cord.
1.
The monitor, when taken out from the
shipping carton, is in the horizontal
position. Holding the base of the
monitor with one hand and the rear
center of the monitor in the other
hand. Turn the panel up to the vertical
position until you hear the base click
into place.
shipping carton, is in the horizontal
position. Holding the base of the
monitor with one hand and the rear
center of the monitor in the other
hand. Turn the panel up to the vertical
position until you hear the base click
into place.
2.
Place the monitor on a flat surface in
a well-ventilated location near your
computer.
a well-ventilated location near your
computer.
3.
Connect the signal cable 1 to the
VGA port of the computer. Tighten the two thumbscrews by turning clock wise to
ensure proper grounding.
VGA port of the computer. Tighten the two thumbscrews by turning clock wise to
ensure proper grounding.
4.
Plug the DC cord of the AC adapter to the power connector 2, then plug the female
end of the AC cord to the AC adapter and the male end to an electrical outlet socket
3
end of the AC cord to the AC adapter and the male end to an electrical outlet socket
3
.
5.
Connect one end of the audio cable to the monitor's Audio Input connector and the
other end to the Audio Output connector of the computer .
other end to the Audio Output connector of the computer .