Netgear Business Edition ユーザーズマニュアル

2-2

Setting Up and Managing Your ReadyNAS Pro

Select Network > Interfaces > Ethernet 1 /Ethernet 2 tab pages to specify network interface-
specific settings for Standard Settings, Teaming/Failover, VLAN Settings and Performance 
Settings. 

Standard Setting. In this section, you can specify the IP address, network mask, speed/duplex 
mode, and MTU settings. In most networks where a DHCP server is enabled, you can simply 
specify the Use values from a DHCP server option to automatically set the IP address and 
network mask.

IP Assignment. Select either Use values from a DHCP server or Use values below.

–

If you elect to assign the IP address using Use values from a DHCP server, NETGEAR 
advises that you set the lease time on the DHCP server/router to a value of at least a day. 
Otherwise, you might notice that the IP address of the unit changes even when it has been 
powered down for only a few minutes. Most DHCP servers allow you to assign a static IP 
address for specified MAC addresses. If you have this option, this would be a good way to 
ensure your ReadyNAS Pro Business Edition maintains the same IP address even in 
DHCP mode.

–

If you assign a static IP address by selecting Use values below, be aware that the browser 
will lose connection to the ReadyNAS Pro Business Edition device after the IP address has 
been changed. To reconnect after assigning a static IP address, open RAIDar and click 
Rescan to locate the device, and then reconnect.

•

Speed/Duplex Mode (Only applies to 10/100 connections). If you have a managed switch 
that works best if the devices are forced to a particular speed or duplex mode, you can select