ONKYO BR925 ユーザーズマニュアル
36
You must store some presets before you can select them
(see pages 34 and 35).
(see pages 34 and 35).
You can also use the front panel controls.
1 Use the [INPUT] button to select “AM” or “FM”.
1 Use the [INPUT] button to select “AM” or “FM”.
2 Turn the MULTI JOG dial to select a preset.
Tuning into weak stereo FM stations
If the signal from a stereo FM station is weak, it may be
impossible to get good reception. In this case, switch to
Manual Tuning mode and listen to the station in mono.
impossible to get good reception. In this case, switch to
Manual Tuning mode and listen to the station in mono.
Noise and sound interruption can be reduced.
When returning to Auto Tuning Mode, press the ENTER
again. Normally, leave the AUTO indicator displayed.
The CD/HDD receiver automatically receives FM radio
in stereo.
When returning to Auto Tuning Mode, press the ENTER
again. Normally, leave the AUTO indicator displayed.
The CD/HDD receiver automatically receives FM radio
in stereo.
Selecting Preset Stations
1
Use the [BAND] or INPUT [
q]/[w]
button to select “AM” or “FM”.
The preset you selected the last time you
listened to the radio will still be selected.
The preset you selected the last time you
listened to the radio will still be selected.
2
Use the Previous and Next
[
[
7]/[6] buttons to select a
preset.
Press the Previous [
Press the Previous [
7] button to select
the previous preset. Press the Next
[
[
6] button to select the next preset.
Tip:
• You can also use the number buttons as
• You can also use the number buttons as
shown in the examples below to select
presets.
presets.
BAND
/
(PRESET / )
or
To select:
Press:
Preset #8
Used to enter numbers over 10.
Preset #10
Preset #22
FM 87.50 MHz 1 ch
AUTO indicator
FM 87.50 MHz 1 ch