Samsung T1000LM026 ユーザーズマニュアル

ページ / 111
Spinpoint M8U-Internal Product Manual REV 3.4 
31 
INSTALLATION 
 
 
 
5.5.3    Defect Management 
 
 
The Spinpoint M8U  hard disk drive media is scanned  for defects.     After defect scanning,  the defective  sectors 
are  saved  in  the  defect  list.     A  defect  encountered  in  the  manufacturing  process  is  slipped  to  the  next 
physical  sector  location.     All  logical  sector  numbers  are  pushed  down  to  maintain  a  sequential  order  of 
data.     The read/write  operation  can  “slip”  over  the  defective  sectors  so  that  the  only  performance  impact  is 
idle time. 
 
 
5.5.4    Automatic Defect Allocation 
 
 
The  automatic  defect  allocation  feature  automatically maps  out  defective  sectors  encountered during  read 
sector  or  write  sector  operations.     These  types  of  defective  sectors  are  typically  caused  by  grown  defects. 
During  write  operations,  if  write  errors  are  encountered,  all  sectors  within  the  target  servo  frame  are  mapped 
out.     Original  data  is  transferred  and  written  into  designated  reserved  sector  areas  determined  by  the  HDD 
firmware. 
 
 
5.5.5    Multi-burst ECC Correction 
 
 
The  drive  uses  a  Reed-Solomon  code  to  perform  error  detection  and  correction.     For  each  512  byte  block, 
the software error correction  polynomial  is capable of correcting: 
 
•      One 191-bit burst error 
•      Up to 48 bytes with reassure pointer (off-line correction) 
 
These errors are corrected on the fly with no performance  degradation.