Seagate ST2000VN000 ユーザーズマニュアル
NAS HDD Product Manual, Rev. A
17
Drive Specifications
2.8.4 Power-management modes
The drive provides programmable power management to provide greater energy efficiency. In most systems, you
can control power management through the system setup program. The drive features the following power-
management modes:
can control power management through the system setup program. The drive features the following power-
management modes:
• Active mode
The drive is in Active mode during the read/write and seek operations.
• Idle mode
The buffer remains enabled, and the drive accepts all commands and returns to Active mode any time disk
access is necessary.
access is necessary.
• Standby mode
The drive enters Standby mode when the host sends a Standby Immediate command. If the host has set the
standby timer, the drive can also enter Standby mode automatically after the drive has been inactive for a
specifiable length of time. The standby timer delay is established using a Standby or Idle command. In
Standby mode, the
standby timer, the drive can also enter Standby mode automatically after the drive has been inactive for a
specifiable length of time. The standby timer delay is established using a Standby or Idle command. In
Standby mode, the
drive buffer is enabled, the heads are parked and the spindle is at rest. The drive accepts
all commands and returns to Active mode any time disk access is necessary.
• Sleep mode
The drive enters Sleep mode after receiving a Sleep command from the host. In Sleep mode, the drive buffer is
disabled, the heads are parked and the spindle is at rest. The drive leaves Sleep mode after it receives a Hard
Reset or Soft Reset from the host. After receiving a reset, the drive exits Sleep mode and enters Standby mode
with all current translation parameters intact.
disabled, the heads are parked and the spindle is at rest. The drive leaves Sleep mode after it receives a Hard
Reset or Soft Reset from the host. After receiving a reset, the drive exits Sleep mode and enters Standby mode
with all current translation parameters intact.
• Idle and Standby timers
Each time the drive performs an Active function (read, write or seek), the standby timer is reinitialized and
begins counting down from its specified delay times to zero. If the standby timer reaches zero before any drive
activity is required, the drive makes a transition to Standby mode. In both Idle and Standby mode, the drive
accepts all commands and returns to Active mode when disk access is necessary.
begins counting down from its specified delay times to zero. If the standby timer reaches zero before any drive
activity is required, the drive makes a transition to Standby mode. In both Idle and Standby mode, the drive
accepts all commands and returns to Active mode when disk access is necessary.
2.9
Environmental specifications
This section provides the temperature, humidty, shock, and vibration specifications for NAS HDDs. This section
provides the temperature, humidity, shock, and vibration specifications.
provides the temperature, humidity, shock, and vibration specifications.
2.9.1 Drive case temperature
Ambient temperature is defined as the temperature of the environment immediately surrounding the drive. Above
1000ft. (305 meters), the maximum temperature is derated linearly by 1°C every 1000 ft. Drive case temperature
should be measured at the location indicated in
1000ft. (305 meters), the maximum temperature is derated linearly by 1°C every 1000 ft. Drive case temperature
should be measured at the location indicated in
Power modes
Heads
Spindle
Buffer
Active
Tracking
Rotating
Enabled
Idle
Tracking
Rotating
Enabled
Standby
Parked Stopped
Enabled
Sleep
Parked
Stopped
Disabled