Seagate ST200FM0043 ユーザーズマニュアル
Seagate 1200 SSD Product Manual, Rev. C
76
11.4.7 Power
The drive receives power (+3.3 volts, +5 volts and +12 volts) through the SAS device connector.
Three +12 volt pins provide power to the drive, 2 short and 1 long. The current return for the +12 volt power supply is through
the common ground pins. The supply current and return current must be distributed as evenly as possible among the pins.
the common ground pins. The supply current and return current must be distributed as evenly as possible among the pins.
Three +5 volt pins provide power to the drive, 2 short and 1 long. The current return for the +5 volt power supply is through
the common ground pins. The supply current and return current must be distributed as evenly as possible among the pins.
the common ground pins. The supply current and return current must be distributed as evenly as possible among the pins.
Two +3.3 volt pins provide power to the drive, 1 short and 1 long. The current return for the +3.3 volt power supply is through
the common ground pins. The supply current and return current must be distributed as evenly as possible among the pins.
the common ground pins. The supply current and return current must be distributed as evenly as possible among the pins.
Current to the drive through the long power pins may be limited by the system to reduce inrush current to the drive during hot
plugging.
plugging.
11.5
Signal characteristics
This section describes the electrical signal characteristics of the drive’s input and output signals. See Table 23 for signal type
and signal name information.
and signal name information.
11.5.1 Ready LED Out
The Ready LED Out signal is designed to pull down the cathode of an LED. The anode is attached to the proper +3.3 volt
supply through an appropriate current limiting resistor. The LED and the current limiting resistor are external to the drive. See
Table 26 for the output characteristics of the LED drive signals.
supply through an appropriate current limiting resistor. The LED and the current limiting resistor are external to the drive. See
Table 26 for the output characteristics of the LED drive signals.
Table 25 Ready LED Out conditions
Normal command activity
LED status
Ready LED Meaning bit mode page 19h
0
1
Drive stopped, not ready, and no activity
Off
Off
Drive stopped, not ready, and activity
(command executing)
On
On
Drive started, ready, and no activity
On
Off
Drive started, ready, and activity
(command executing)
Off
On
Drive transitioning from not-ready state to
ready state or the reverse.
Blinks steadily
(50% on and 50% off, 0.5 seconds on and off for 0.5 seconds)
FORMAT UNIT in progress,
Toggles on/off
Table 26 LED drive signal
State
Test condition
Output voltage
LED off, high
0 V
VOH
3.6 V
-100 μA < I
OH
< 100 μA
LED o
n, low
I
OL
= 15 mA
0
V
OL
0.225 V