Seagate ST1000VX000 ユーザーズマニュアル

Figure 1 Attaching SATA cabling

Each cable is keyed to ensure correct orientation. Barracuda  drives support latching SATA connectors. 

You can mount the drive in any orientation using four screws in the side-mounting holes or four screws in the 
bottom-mounting holes. See 

mounting precautions when mounting the drive:

• Allow a minimum clearance of 0.030 inches (0.76mm) around the entire perimeter of the drive for cooling.

• Use only 6-32 UNC mounting screws.

• The screws should be inserted no more than 0.150 inch (3.81mm) into the bottom or side mounting holes.

• Do not overtighten the mounting screws (maximum torque: 6 inch-lb).

Power cable

Signal cable

Signal connector

Power connector