Seagate ST9200827AS ユーザーズマニュアル
Momentus 5400.4 SATA Product Manual, Rev. B (Draft 02)
19
3.4
Drive mounting
You can mount the drive using four screws in the side-mounting holes or four screws in the bottom-mounting
holes. See Figure 4 for drive mounting dimensions. Follow these important mounting precautions when mount-
ing the drive:
holes. See Figure 4 for drive mounting dimensions. Follow these important mounting precautions when mount-
ing the drive:
• Allow a minimum clearance of 0.030 inches (0.76 mm) around the entire perimeter of the drive for cooling.
• Use only M3 UNC mounting screws.
• Do not overtighten the mounting screws (maximum torque: 4.0 inch-lb).
• Four (4) threads (0.080 inches) minimum screw engagement recommended.
Measurements shown in Figure 4 are in inches.
Figure 4.
Mounting dimensions—top, side and end view
+
Recommended
case temperature
measurement
location
case temperature
measurement
location
Breather Hole
Do not cover
or seal.
Do not cover
or seal.
Mating surface flatness not to exceed 0.005 inches (0.127 mm)
DRIVE LENGTH W/SATA IS 3.951 + .008 / -.010 (WORST CASE)