Seagate Ultra 160 ユーザーズマニュアル

Parallel SCSI Interface Product Manual, Rev. A                                        

   111

The following subclauses describe some aspects of command processing, including exception conditions and 
error handling that are specific to this standard.

Notification of an asynchronous event is performed using the SEND command with the AER bit set to one. The 
information identifying the condition being reported shall be returned during the data out delivery phase of the 
SEND command (see SCSI Primary Commands-4 standard).

An error condition or unit attention condition shall be reported once per occurrence of the event causing it. The 
target may choose to use an asynchronous event notification or to return CHECK CONDITION status on a 
subsequent command, but not both. Notification of command-related error conditions shall be sent only to the 
initiator that requested the task.

The asynchronous event notification protocol may be used to notify processor devices that a system resource 
has become available. If a SCSI target port chooses to use this method, the sense key in the sense data sent 
to the processor device shall be set to Unit Attention.

The asynchronous event notification protocol shall be used only with SCSI devices that return processor 
device type with an AERC bit of one in response to an INQUIRY command. The INQUIRY command should be 
sent to logical unit zero of each SCSI device responding to selection. This procedure shall be conducted prior 
to the first asynchronous event notification and shall be repeated whenever the SCSI device deems it appropri-
ate or when an event occurs that may invalidate the current information. (See SYNCHRONOUS DATA 
TRANSFER REQUEST message, Section 4.3.16, for examples of these events.)

Each SCSI device that returns processor device type with an AERC bit of one shall be issued a TEST UNIT 
READY command to determine that the SCSI device is ready to receive an asynchronous event notification. A 
SCSI device returning CHECK CONDITION status is issued a REQUEST SENSE command. This clears any 
pending unit attention condition. A SCSI device that returns processor device type with an AERC bit of one and 
returns Good status when issued a TEST UNIT READY command shall accept a SEND command with an 
AER bit of one.

A SCSI device that uses asynchronous event notification at initialization time should provide means to 
defeat these notifications. This may be done with a switch or jumper wire. SCSI devices that imple-
ment saved parameters may alternatively save the asynchronous event notification permissions either 
on a per SCSI device basis or as a system wide option. In any case, a SCSI device conducts a survey 
with INQUIRY commands to be sure that the SCSI devices on the SCSI bus are appropriate destina-
tions for SEND commands with an AER bit of one. (The SCSI devices on the bus or the SCSI ID 
assignments may have changed.)

See asynchronous event reporting in the SCSI Architecture Model-4 standard for more information on asyn-
chronous event notification.

This feature is not likely supported at this time. Check individual drive’s Product Manual, in features supported 
table to see if it is supported by a particular drive model.

An incorrect initiator connection occurs during an initial connection if a SCSI initiator port creates a nexus that 
already exists and does not send an ABORT TASK SET, ABORT TASK, TARGET RESET, CLEAR TASK SET, 
DISCONNECT, or LOGICAL UNIT RESET message as one of the messages of the MESSAGE OUT phase or 
as one of the task management flags in the SPI command information unit.