Seagate ST5000VX0001 ユーザーズマニュアル

Drive acoustics are measured as overall A-weighted acoustic sound power levels (no pure tones). All measurements are
consistent with ISO document 7779. Sound power measurements are taken under essentially free-field conditions over a
reflecting plane. For all tests, the drive is oriented with the cover facing upward.

* During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and power to operational levels.

Seagate follows the ECMA-74 standards for measurement and identification of PDTs. An exception to this process is the use of
the absolute threshold of hearing. Seagate uses this threshold curve (originated in ISO 389-7) to discern tone audibility and to
compensate for the inaudible components of sound prior to computation of tone ratios according to Annex D of the ECMA-74
standards.

When properly installed in a representative host system, the drive operates without errors or degradation in performance when
subjected to the radio frequency (RF) environments defined in 

The product will achieve an Mean Time Between Failure (MTBF) of 1,000,000 hours when operated in an environment of
ambient air temperatures of 25°C. Operation at temperatures outside the specifications shown in Section 2.9, "Environmental
specifications." may decrease the product MTBF. MTBF is a population statistics that is not relevant to individual units.

MTBF specifications are based on the following assumptions for Surveillance environments:

• 8760 power-on-hours per year

• 10,000 average motor start/stop cycles per year

• Operations at nominal voltages

• Normal I/O duty cycle for Surveillance environments. Operation at excessive I/O duty cycle may degrade product reliability.

The Surveillance environment of power-on-hours, temperature, and I/O duty cycle affect the product MTBF. The MTBF will be
degraded if used in an enterprise application.

For seek mode tests, the drive is placed in seek mode only.
The number of seeks per second is defined by the following equation: 
(Number of seeks per second = 0.4 / (average latency + average access time

2.5 bels (typical)
2.6 bels (max)

2.6 bels (typical)
2.7 bels (max)

Electrostatic discharge

Contact, HCP, VCP: ± 4 kV; Air: ± 8 kV

B

EN61000-4-2: 95

Radiated RF immunity

80MHz to 1,000MHz, 3 V/m, 
80% AM with 1kHz sine
900MHz, 3 V/m, 50% pulse modulation @ 
200Hz

A

EN61000-4-3: 96
ENV50204: 95

Electrical fast transient

± 1 kV on AC mains, ± 0.5 kV on external I/O

B

EN61000-4-4: 95

Surge immunity

± 1 kV differential, ± 2 kV common,

AC mains

B

EN61000-4-5: 95

Conducted RF immunity

150kHz to 80MHz, 3 Vrms, 80% AM with 1kHz 
sine

A

EN61000-4-6: 97

Voltage dips, interrupts

0% open, 5 seconds
0% short, 5 seconds
40%, 0.10 seconds
70%, 0.01 seconds

C
C
C
B

EN61000-4-11: 94