Seagate Ultra 320 ユーザーズマニュアル
106
Parallel SCSI Interface Product Manual, Rev. A
4.5.3
ABORT TASK SET
The ABORT TASK SET message is defined in the SCSI Architecture Model-4 standard. In addition to the
requirements in the SCSI Architecture Model-4 standard the target shall go to the BUS FREE phase following
the successful receipt of the ABORT TASK SET message.
requirements in the SCSI Architecture Model-4 standard the target shall go to the BUS FREE phase following
the successful receipt of the ABORT TASK SET message.
If only an I_T nexus has been established, the target shall switch to a BUS FREE phase. No status or message
shall be sent for the current task and no pending data, status, or tasks are affected.
shall be sent for the current task and no pending data, status, or tasks are affected.
Note.
The ABORT TASK SET message in the case of only an I_T nexus is useful to an initiator that is not
able to send an Identify message through to the target due to parity errors and just needs to end the
current task or task management function. It is not an error to issue this message to an I_T_L nexus
that does not have any pending or current tasks.
able to send an Identify message through to the target due to parity errors and just needs to end the
current task or task management function. It is not an error to issue this message to an I_T_L nexus
that does not have any pending or current tasks.
4.5.4
CLEAR ACA
The CLEAR ACA message is defined in the SCSI Architecture Model-4 standard.
The CLEAR ACA message shall only be sent by an initiator during an initial connection. If the target receives
the CLEAR ACA message at any other time the target shall switch to a Message In phase and issue a MES-
SAGE REJECT message. The target shall then continue processing the task that was in process when the
CLEAR ACA message was received.
the CLEAR ACA message at any other time the target shall switch to a Message In phase and issue a MES-
SAGE REJECT message. The target shall then continue processing the task that was in process when the
CLEAR ACA message was received.
On receipt of a CLEAR ACA message, the task manager, in addition to clearing the ACA condition, shall go to
the BUS FREE phase following the successful receipt of the CLEAR ACA message.
the BUS FREE phase following the successful receipt of the CLEAR ACA message.
It is not an error to issue a CLEAR ACA message when no ACA condition is in effect.
4.5.5
CLEAR TASK SET
The CLEAR TASK SET message is defined in the SCSI Architecture Model-4 standard.
In addition to the requirements in the SCSI Architecture Model-4 standard, the target shall go to the BUS FREE
phase following the successful receipt of the CLEAR TASK SET message.
phase following the successful receipt of the CLEAR TASK SET message.
4.5.6
LOGICAL UNIT RESET
The LOGICAL UNIT RESET message is defined in the SCSI Architecture Model-4 standard.
Receipt of the LOGICAL UNIT RESET message after an I_T_L nexus has been astablished is a logical unit
reset event as defined in the SCSI Architecture Model-4 standard.
reset event as defined in the SCSI Architecture Model-4 standard.
In addition to the requirements in the SCSI Architecture Model-4 standard, the target shall go to the BUS FREE
phase following the successful receipt of the LOGICAL UNIT RESET message.
phase following the successful receipt of the LOGICAL UNIT RESET message.
4.5.7
TARGET RESET
The TARGET RESET message is defined in the SCSI Architecture Model-4 standard.
In addition to the requirements in the SCSI Architecture Model-4 standard, the target shall go to the BUS FREE
phase following the successful receipt of the TARGET RESET message.
phase following the successful receipt of the TARGET RESET message.