Seagate ST600MP0084 - 4K ユーザーズマニュアル

S

EAGATE 

E

NTERPRISE 

P

ERFORMANCE 

15K HDD 

AND 

E

NTERPRISE 

T

URBO 

SSHD SAS P

RODUCT 

M

ANUAL

, R

EV

. B

 

 42

  

Enterprise Performance 15K HDD and Enterprise  Turbo SSHD disk drive installation is a  plug-and-play process. There are no jumpe rs, 

switches, or terminators on the drive.

SAS drives are designed to be used in a host system that provides a SAS-compatible backplane with bays designed to accommodate the 

drive. In such systems, the host system typically provides a carrier or tray into which the drive needs to be mounted. Mount the drive to the 

carrier or tray provided by the host system using four M3 x 0.5 metric screws. When tightening the screws, use a maximum torque  of 4.5 

in-lb +/- 0.45 in-lb. Do not over-tighten or force the screws. Mount the drive in any orientation.
Note.

SAS drives are designed to be attached to the host system without I/O or power cables. If it is intended to use the drive in a 

non-backplane host system, connecting the drive using high-quality cables is acceptable as long as the I/O cable length does 

not exceed 10 m (32.8 ft).

Slide the carrier or tray into the appropriate bay in the host system using the instructions provided by the host system. This  connects the 

drive directly to the system’s SAS connector. The SAS connector is normally located on a SAS backpanel. See Section 11.4.1 for 

additional information about these connectors.

Power is supplied through the SAS connector. 

The drive is shipped from the factory low-level formatted in 512-byte logical blocks. Reformatting the driveis needed only if wanting to 

select a different logical block size.

The drive may be mounted in any orientation. All drive performance characterizations, however, have been done with the drive in 

horizontal (disks level) and vertical (drive on its side) orientations, which are the two preferred mounting orientations.

Cabinet cooling must be designed by the customer so that the ambient temperature immediately surrounding the drive will not exceed 

temperature conditions specified in Section 6.5.1, "Temperature."

The rack, cabinet, or drawer environment for the drive must provide heat removal from the electronics and head and disk assembly (HDA). 

Forced air flow may be required to keep temperatures at or below the temperatures specified in Section 6.5.1 in which case the drive 

should be oriented, or air flow directed, so that the least amount of air flow resistance is created while providing air flow t o the electronics 

and HDA. Also, the shortest possible path between the air inlet and exit should be chosen to minimize the travel length of air heated by the 

drive and other heat sources within the rack, cabinet, or drawer environment.