Seagate ST940210A ユーザーズマニュアル

LD25 Series 5400.2 Product Manual, Rev. C

19

This section contains the specifications and instructions for configuring and mounting the drive.

After unpacking, and before installation, the drive may be exposed to potential handling and electrostatic dis-
charge (ESD) hazards. Observe the following standard handling and static-discharge precautions:

• Keep the drive in the electrostatic discharge (ESD) bag until you are ready for installation to limit the drive’s 

exposure to ESD.

• Before handling the drive, put on a grounded wrist strap, or ground yourself frequently by touching the metal 

chassis of a computer that is plugged into a grounded outlet. Wear a grounded wrist strap throughout the entire 
installation procedure.

• Handle the drive only by its edges or frame.

• The drive is fragile—handle it with care. Do not press down on the drive top cover.

• Always rest the drive on a padded, antistatic surface until you mount it in the computer.

• Do not touch the connector pins or the printed circuit board.

Do not remove the factory-installed labels from the drive or cover them with additional labels. Removal voids 
the warranty. Some factory-installed labels contain information needed to service the drive. Other labels are 
used to seal out dirt and contamination.

Mount the drive using four screws in the side-mounting holes or four screws in the bottom-mounting holes. See 
Figure 2 for drive mounting dimensions. Follow these important mounting precautions when mounting the 
drive:

• Allow a minimum clearance of 0.030 inches (0.76 mm) around the entire perimeter of the drive for cooling.

• Use only M3 UNC mounting screws.

• Do not overtighten the mounting screws (maximum torque: 4.0 inch-lb).

• Four (4) threads (0.080 inches) minimum screw engagement recommended.