Seagate ST5000AS0001 ユーザーズマニュアル

Seagate Archive HDD Product Manual, Rev. C

20 

These drives use the industry-standard Serial ATA (SATA) interface that supports FIS data transfers. It supports
ATA programmed input/output (PIO) modes 0 to 4; multiword DMA modes 0 to 2, and Ultra DMA modes 0 to 6.
For detailed information about the SATA interface, refer to the “Serial ATA: High Speed Serialized AT Attachment”
specification.

www.serialata.org

.

 summarizes the signals on the SATA interface and power connectors.

1.

All pins are in a single row, with a 1.27 mm (0.050”) pitch.

2.

The comments on the mating sequence apply to the case of backplane blindmate connector only.
In this case, the mating sequences are:

•  the ground pins P4 and P12.
•  the pre-charge power pins and the other ground pins.
•  the signal pins and the rest of the power pins.

3.

There are three power pins for each voltage.
One pin from each voltage is used for pre-charge when installed in a blind-mate backplane configuration.

•  All used voltage pins (V

x

) must be terminated.

The drive motor must come to a complete stop (Ready to spindle stop time indicated in Section 2.6) 
prior to changing the plane of operation.This time is required to insure data integrity.

S1

Ground

2nd mate

S2

A+

Differential signal pair A from Phy

S3

A-

S4

Ground

2nd mate

S5

B-

Differential signal pair B from Phy

S6

B+

S7

Ground

2nd mate

Key and spacing separate signal and power segments

P1

V

33

3.3V power

P2

V

33

3.3V power

P3

V

33

3.3V power, pre-charge, 2nd mate

P4

Ground

1st mate

P5

Ground

2nd mate

P6

Ground

2nd mate

P7

V

5

5V power, pre-charge, 2nd mate

P8

V

5

5V power

P9

V

5

5V power

P10

Ground

2nd mate

P11

Ground or LED signal

If grounded, drive does not use deferred spin

P12

Ground

1st mate.

P13

V

12

12V power, pre-charge, 2nd mate

P14

V

12

12V power

P15

V

12

12V power