Seagate ST9320328CS ユーザーズマニュアル

22

Pipeline HD Mini Series SATA Product Manual, Rev. E

Notes:
1. All pins are in a single row, with a 1.27 mm (0.050”) pitch.

2. The comments on the mating sequence apply to the case of backplane blindmate connector only. In this case, 

the mating sequences are:

• the ground pins P4 and P12.
• the pre-charge power pins and the other ground pins.
• the signal pins and the rest of the power pins.

3. There are three power pins for each voltage. One pin from each voltage is used for pre-charge when installed 

in a blind-mate backplane configuration.

4. All used voltage pins (V

x

) must be terminated.

The following table lists Serial ATA standard commands that the drive supports. For a detailed description of the 
ATA commands, refer to the Serial ATA: High Speed Serialized AT Attachment specification. See “S.M.A.R.T. com-
mands” on page

P1

V

33

3.3V power

P2

V

33

3.3V power

P3

V

33

3.3V power, pre-charge, 2nd mate

P4

Ground

1st mate

P5

Ground

2nd mate

P6

Ground

2nd mate

P7

V

5

5V power, pre-charge, 2nd mate

P8

V

5

5V power

P9

V

5

5V power

P10

Ground

2nd mate

P11

Reserved

The pin corresponding to P11 in the backplane receptacle connector is also reserved
The corresponding pin to be mated with P11 in the power cable receptacle connector shall 

always be grounded

P12

Ground

1st mate.

P13

V

12

12V power, pre-charge, 2nd mate

P14

V

12

12V power

P15

V

12

12V power

Configure Stream

51h

Device Configuration Restore

B1h/C0h

Device Configuration Freeze Lock

B1h/C1h