Seagate ST32430N/ND ユーザーズマニュアル
6
Hawk 2LP Family Installation Guide, Rev. B
_____________________________________________________________________________________________________________
Safety instructions
1.
The disc drive(s) are to be installed in a customer
supplied enclosure where the surrounding air does
not exceed 50
supplied enclosure where the surrounding air does
not exceed 50
o
C.
2.
Four (4) 6-32 UNC-2A screws are required for
installation. Maximum screw length into side of
drive is 0.15 inches (3.81 mm). Maximum screw
length into bottom is 0.20 in. (5.08 mm). Screw
tightening torques is 6.0 lb-in (.675 NM) max with
minimum thread engagement of 0.12 in (3.00 mm).
installation. Maximum screw length into side of
drive is 0.15 inches (3.81 mm). Maximum screw
length into bottom is 0.20 in. (5.08 mm). Screw
tightening torques is 6.0 lb-in (.675 NM) max with
minimum thread engagement of 0.12 in (3.00 mm).
3.
The power requirements are shown in the Product
Information section.
Information section.
4.
The power supply must satisfy the safety require-
ments for SELV (Safety Extra Low Voltage) cir-
cuits.
ments for SELV (Safety Extra Low Voltage) cir-
cuits.
5.
Service is to be provided by trained Seagate ser-
vice personnel.
vice personnel.
6.
The incorporation of the disc drives listed in this
guide into a customer enclosure must meet the
appropriate safety requirements of the country in
which it is used (e.g. UL 1950, CAN/CSA-C22.2
No. 950-M89, DIN VDE 0805:1993 and EN60950:
1992 (IEC 950).
guide into a customer enclosure must meet the
appropriate safety requirements of the country in
which it is used (e.g. UL 1950, CAN/CSA-C22.2
No. 950-M89, DIN VDE 0805:1993 and EN60950:
1992 (IEC 950).
Note
Power must be off when connecting or disconnecting.