Seagate ST34573N/W/WD/LW/WC/LC ユーザーズマニュアル
52
Barracuda 9LP Installation Guide, Rev. E
WC/LC drives
WC/DC drives section
Setting the SCSI ID jumpers
The SCSI ID for “WC” and “LC” model drives is normally set over
the SCSI bus by the host system using connector contacts 39
(ID0), 40 (ID2), 79 (ID1), and 80 (ID3). Users need not install
jumpers to select SCSI ID.
the SCSI bus by the host system using connector contacts 39
(ID0), 40 (ID2), 79 (ID1), and 80 (ID3). Users need not install
jumpers to select SCSI ID.
Terminating the drive
“WC” and “LC” model drives do not have internal terminators or
any other way of adding internal termination to the drive. Exter-
nal termination for these drives must be supplied by the host
equipment.
any other way of adding internal termination to the drive. Exter-
nal termination for these drives must be supplied by the host
equipment.