Seagate ST9655AG ユーザーズマニュアル
•
Verify hardware compatibility. Check the documentation
for your drive, host adapter and computer to confirm that these
components are compatible.
for your drive, host adapter and computer to confirm that these
components are compatible.
•
Verify your hardware configuration. Check the documen-
tation for your drive, host adapter and computer to confirm
that all jumpers are set appropriately.
tation for your drive, host adapter and computer to confirm
that all jumpers are set appropriately.
•
Check all cables. Make sure that all cables are securely
connected. Printed circuit and ribbon cables are quite fragile.
Check to see that they are not crimped or damaged. Make
sure that pin 1 of the interface cable is connected to pin 1 of
the interface connector on the drive and on the computer.
Most ribbon cables have a stripe down one side to designate
pin 1. The location of pin 1 on the drive interface connector is
shown in Figure 1 on page 3.
connected. Printed circuit and ribbon cables are quite fragile.
Check to see that they are not crimped or damaged. Make
sure that pin 1 of the interface cable is connected to pin 1 of
the interface connector on the drive and on the computer.
Most ribbon cables have a stripe down one side to designate
pin 1. The location of pin 1 on the drive interface connector is
shown in Figure 1 on page 3.
•
Check all cards. If your computer has expansion cards,
check to see that they are inserted completely into their slots
on the motherboard and are secured with appropriate mount-
ing screws. Make sure that full-size (16-bit) cards are not
plugged into half-size (8-bit) slots.
check to see that they are inserted completely into their slots
on the motherboard and are secured with appropriate mount-
ing screws. Make sure that full-size (16-bit) cards are not
plugged into half-size (8-bit) slots.
•
Verify the BIOS drive type. Make sure that you entered the
correct drive type or translation geometry in the BIOS setup
program. The drive capacity and number of sectors specified
in the BIOS must not exceed the specifications shown in the
table on page 6. If the drive type is incorrect, you must rerun
the system setup program. Then partition and high-level
format the drive again.
correct drive type or translation geometry in the BIOS setup
program. The drive capacity and number of sectors specified
in the BIOS must not exceed the specifications shown in the
table on page 6. If the drive type is incorrect, you must rerun
the system setup program. Then partition and high-level
format the drive again.
•
Check for I/O address conflicts. To isolate an address
conflict, first verify that the drive and host adapter are com-
patible with your system by disconnecting all other peripherals
except the video card. Then install the drive and host adapter,
and test the system. Next, install the other peripherals, one at
conflict, first verify that the drive and host adapter are com-
patible with your system by disconnecting all other peripherals
except the video card. Then install the drive and host adapter,
and test the system. Next, install the other peripherals, one at
ST9655 Family Installation Guide, Rev. A
11