Seagate ST373405LW/LWV/LC/LCV ユーザーズマニュアル

Table 10 and Section 9.5.2 list Synchronous Data transfer periods supported by the drive. The data transfer
period to be used by the drive and the initiator is established by an exchange of messages during the Message
Phase of operation. See the section on message protocol in the 

SCSI Interface Product Manual, part number

75789509.

[1]

This transfer rate is only allowed when using the LVD interface.

[2]

You must use the Parallel Protocol Request message with this transfer rate.

The maximum value supported by the Cheetah 73LP family drives for REQ/ACK offset is 63 (3Fh).

This section describes the connectors, cables, signals, terminators and bus timing of the DC and SCSI I/O
interface. See Section 9.8 and Section 9.9 for additional terminator information.

Figures 19 and 20 show the locations of the DC power connector, SCSI interface connector, drive select head-
ers, and option select headers.

Details of the physical, electrical and logical characteristics are given in sections following, while the SCSI
operational aspects of Seagate drive interfaces are given in the 

SCSI Interface Product Manual, part number

75789509.

LW and LWV model drives receive DC power through a 4 pin connector (see Figure 21 for pin assignment)
mounted at the rear of the main PCBA. Recommended part numbers of the mating connector are listed below,
but equivalent parts may be used.

LC and LCV model drives receive power through the 80-pin I/O connector. See Tables 14 and 15.

9

12.5

80.0 [1] [2]

10

25

40.0 [1]

12

50

20.0

25

100

10.0

50

200

5.0

14 AWG

MP 1-480424-0

AMP 60619-4 (Loose Piece)

AMP 61117-4 (Strip)