Seagate ST9146652SS ユーザーズマニュアル
32
Savvio 15K.2 SAS Product Manual, Rev. F
7.4.4.2
Vibration
a. Operating—normal
The drive as installed for normal operation, shall comply with the complete specified performance while
subjected to continuous vibration not exceeding
subjected to continuous vibration not exceeding
5 - 500 Hz, swept sine: 0.5 G (zero to peak)
10 - 500 Hz, random: 0.00051 G
2
/Hz
Vibration may be applied in the X, Y, or Z axis.
b. Operating—abnormal
Equipment as installed for normal operation shall not incur physical damage while subjected to periodic
vibration not exceeding:
vibration not exceeding:
15 minutes of duration at major resonant frequency
5 - 500 Hz, swept sine: 0.75 G (zero to peak)
10 - 500 Hz, random: 0.0029 G
2
/Hz
Vibration occurring at these levels may degrade operational performance during the abnormal vibration
period. Specified operational performance will continue when normal operating vibration levels are
resumed. This assumes system recovery routines are available.
period. Specified operational performance will continue when normal operating vibration levels are
resumed. This assumes system recovery routines are available.
c. Non-operating
The limits of non-operating vibration shall apply to all conditions of handling and transportation. This
includes both isolated drives and integrated drives.
includes both isolated drives and integrated drives.
The drive shall not incur physical damage or degraded performance as a result of continuous vibration not
exceeding:
exceeding:
5 - 22 Hz, swept sine: 0.25 G, (zero to peak)
22 - 350 Hz, swept sine: 5.0 G (zero to peak)
350 - 500 Hz, swept sine: 1.0 G (zero to peak)
10 - 500 Hz, random: 0.0118 G
2
/Hz
Vibration may be applied in the X, Y, or Z axis.
7.4.5
Air cleanliness
The drive is designed to operate in a typical office environment with minimal environmental control.
7.4.6
Corrosive environment
Seagate electronic drive components pass accelerated corrosion testing equivalent to 10 years exposure to
light industrial environments containing sulfurous gases, chlorine and nitric oxide, classes G and H per ASTM
B845. However, this accelerated testing cannot duplicate every potential application environment.
light industrial environments containing sulfurous gases, chlorine and nitric oxide, classes G and H per ASTM
B845. However, this accelerated testing cannot duplicate every potential application environment.
Users should use caution exposing any electronic components to uncontrolled chemical pollutants and corro-
sive chemicals as electronic drive component reliability can be affected by the installation
sive chemicals as electronic drive component reliability can be affected by the installation
environment. The sil-
ver, copper, nickel and gold films used in Seagate products are especially sensitive to the presence of sulfide,
chloride, and nitrate contaminants. Sulfur is found to be the most damaging. In addition, electronic components
should never be exposed to condensing water on the surface of the printed circuit board assembly (PCBA) or
exposed to an ambient relative humidity greater than 95%. Materials used in cabinet fabrication, such as vulca-
nized rubber, that can outgas corrosive compounds should be minimized or eliminated. The useful life of any
electronic equipment may be extended by replacing materials near circuitry with sulfide-free alternatives.
chloride, and nitrate contaminants. Sulfur is found to be the most damaging. In addition, electronic components
should never be exposed to condensing water on the surface of the printed circuit board assembly (PCBA) or
exposed to an ambient relative humidity greater than 95%. Materials used in cabinet fabrication, such as vulca-
nized rubber, that can outgas corrosive compounds should be minimized or eliminated. The useful life of any
electronic equipment may be extended by replacing materials near circuitry with sulfide-free alternatives.