Seagate ST3146855LW ユーザーズマニュアル

Cheetah 15K.5 SCSI Product Manual, Rev. J

41

     

[1]

Notes explaining the functions of the various jumpers on J5 and J6 jumper header connectors are given 
here and in Section 9.1.2. The term “default” means as standard OEM units are configured with a jumper 
on those positions when shipped from factory. “Off” means no jumper is installed; “On” means a jumper is 
installed. OFF or ON underlined is factory default condition.

 

 
The PCBA on LC models does not have connector J5 or J6. The J5 connector signals conform to SFF-
8009 Revision 2.0, Unitized Connector for Cabled Drives, signal assignments for auxiliary connectors.

[2]

These signals are also on 80-pin J1 I/O connector. See tables 19 and 20, note 9.

[3]

Voltage supplied by the drive.

[4]

Dashed area is optional host circuitry (external to the drive) connected to host supplied optional usage 
plug.

[5]

Do not connect anything to J5 pins 9, 11-12 or J6 pins 13-20.

[6]

Connect an external Drive Activity LED to J5 pin 8 (see Figure 10) and the drive’s +5V power source, 
through an appropriately sized current limiting resistor.

Jumper Plug 

(enlarged to 
show detail) 

Pin 1 

Reserved 

[1] [5] 

Parity Disable

Term. Power to SCSI Bus 

S
E

 

D 
S 

 

M 

E 

 

W 

P 

P
D

 

T 
P 

Force Single-ended Bus Mode

Write Protect 

Enable Remote Motor Start 

Delay Motor Start