Seagate ST34501WC ユーザーズマニュアル
Cheetah 4LP Installation Guide, Rev. B
39
N drives
N drives sectionb
Setting the SCSI ID jumpers
Use the J6 connector to set the SCSI ID (see Figure 7). To
change the SCSI ID, install jumpers on the appropriate pins as
shown in the illustration.
change the SCSI ID, install jumpers on the appropriate pins as
shown in the illustration.
Figure 7.
Setting the SCSI ID on model “N” drives
J6
J2
Pin 1
End
SCSI ID = 0 (default)
Jumper Plug
(enlarged to
show detail)
show detail)
J6 [4]
SCSI ID = 1
SCSI ID = 2
SCSI ID = 3
SCSI ID = 4
SCSI ID = 5
SCSI ID = 6
SCSI ID = 7
Pin 1