Seagate ST92503010AS ユーザーズマニュアル

18

Momentus Thin Series SATA Product Manual, Rev. A

You can mount the drive using four screws in the side-mounting holes or four screws in the bottom-mounting 
holes. See Figure 4 for drive mounting dimensions. Follow these important mounting precautions when mount-
ing the drive:

• Allow a minimum clearance of 0.030 inches (0.76 mm) around the entire perimeter of the drive for cooling.

• Use only M3 UNC mounting screws.

• Do not overtighten the mounting screws. Maximum torque: 4.0 in-lb (0.4519 N-m).

• Four (4) threads (0.080 inches, 2.032 mm) minimum screw engagement recommended.

• Avoid excessive drive distortion when mounting. Refer to the following specifications for stiffness/deflection 

information: 

Operating with no performance degradation, emitted noise, 
mechanical damage, or hard errors

10 mm probe: 1.02kgf or 
  5 mm probe: 0.92kgf

Non-operating with no hard errors

20 mm probe: 2kgf at any point of top cover
20 mm probe: 15kgf at top cover edges only

 

Measurements shown in Figure 4 are in inches.