Sony LIB-81 ユーザーズマニュアル
71
Chapter 6 Using the Library Administration Menu
Key Operation
Click to select whether or not to enable the buttons (the power standby
switch and control buttons) on the front panel. If “Disable” is selected, the
buttons will not function.
Click to select whether or not to enable the buttons (the power standby
switch and control buttons) on the front panel. If “Disable” is selected, the
buttons will not function.
Note
If the library power is turned off, the “Key Operation” setting is returned to
“Enable”.
“Enable”.
R-MIC
If you are using a model equipped with an R-MIC reader, set whether to
enable to enable the R-MIC function when using an AIT-5, AIT-4,
AIT-3 Ex, or AIT-3 cartridge, or AIT-2 cartridge with R-MIC. When using
AIT-2 cartridges without R-MIC or AIT-1 cartridges, select “Disable”.
If you are using a model equipped with an R-MIC reader, set whether to
enable to enable the R-MIC function when using an AIT-5, AIT-4,
AIT-3 Ex, or AIT-3 cartridge, or AIT-2 cartridge with R-MIC. When using
AIT-2 cartridges without R-MIC or AIT-1 cartridges, select “Disable”.
Barcode
When the AIT library is equipped with a bar code reader, set whether or not
to read the bar code affixed to the cartridge. If “Disable” is selected, the bar
code will not be read.
When the AIT library is equipped with a bar code reader, set whether or not
to read the bar code affixed to the cartridge. If “Disable” is selected, the bar
code will not be read.
Caution
• When the AIT library is not equipped with a bar code reader, do not
change the setting to “Enable” as this causes an error to be displayed
when the library starts or when a cartridge is set.
when the library starts or when a cartridge is set.
• If you selected “Enable” for the R-MIC setting and use cartridges without
R-MIC, or if you selected “Enable” for the bar code setting and use
cartridges without bar code labels, initialization after turning on the
library or using the cartridges becomes unusually long. Make sure that
you use appropriate cartridges and settings.
cartridges without bar code labels, initialization after turning on the
library or using the cartridges becomes unusually long. Make sure that
you use appropriate cartridges and settings.
3
Click “Submit”.
The library is configured.
Network
In “Network”, network-related settings can be configured. After configuring,
the AIT library must be restarted.
the AIT library must be restarted.
Note
The network settings can also be configured with the Network Menu of the
control panel.
control panel.
1
Click “System Configuration” on the Library Administration Menu, then
click “Network”. You can also directly click “Network” which is located
below “System Configuration”.
click “Network”. You can also directly click “Network” which is located
below “System Configuration”.
The page to enter the password appears.