FieldServer FS-8700-86 ユーザーズマニュアル
FS-8700-86 Carrier DataPort
Page 8 of 32
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com
Tel: (408) 262 2299 Fax: (408) 262 2269 Toll Free: (888) 509 1970 email: support@fieldserver.com
4.4.
Client Side Map Descriptors
4.4.1.
FieldServer Related Map Descriptor Parameters
Column Title
Function
Legal Values
Map_Descriptor_Name Name of this Map Descriptor
Up to 32 alphanumeric characters
Data_Array_Name
Name of Data Array where data is
to be stored in the FieldServer
to be stored in the FieldServer
One of the Data Array names from
“Data Array” section above
“Data Array” section above
Data_Array_Location
Starting location in Data Array
0 to maximum specified in “Data
Array” section above
Array” section above
Function
Function of Client Map Descriptor
Rdbc, Wrbc, Wrbx
4.4.2.
Driver Related Map Descriptor Parameters
Column Title
Function
Legal Values
Node_Name
Name of Node to fetch data from
One of the node names
specified
specified
in
“Client
Node
Descriptor” above
Data_Type
This commonly used parameter is not
required for this driver.
required for this driver.
Length
Length of Map Descriptor. When reading a
compete table, set the length to the
maximum number of data values you want
stored.
Additional information on the length
parameter is provided in Appendix A.3.
compete table, set the length to the
maximum number of data values you want
stored.
Additional information on the length
parameter is provided in Appendix A.3.
1 – 1000
Address
This commonly used parameter is not required for this driver.
Store_As*
Use the ASCII or AsciiLog format when
you
you
are
discovering
the
variables
contained in a table by reading a table.
Refer to Appendix A for more information.
Refer to Appendix A for more information.
ASCII, AsciiLog, Values
DA_Byte_Name*
If defined, the driver stores the ‘field status’
value in this array.
value in this array.
The name of a Data Array
defined in the Data_Array
section of the configuration file.
defined in the Data_Array
section of the configuration file.
DA_Float_Name*
If defined, the driver stores the ‘field units’
value in this array.
value in this array.
The name of a Data Array
defined in the Data_Array
section of the configuration file.
defined in the Data_Array
section of the configuration file.
4.4.3.
Timing Parameters
Column Title
Function
Legal Values
Scan_Interval
Rate at which data is polled
>0.1s