EDGE Tech ECAT1000 ユーザーズマニュアル

 

7

 

 

1.  The boost sensor is 

located on the 
driver’s side of the 
engine as shown in 
the photo.   
Disconnect the 
stock connector and 
plug in the supplied 
connectors that are 
located closest to 
the Power Edge EZ 
CAT module. 

 
 

 

2.  The IAP sensor is located on the driver’s side towards the front of the engine.  

Disconnect the stock connector and plug in the connectors located at the end of 
the EZ CAT harness (furthest from the module). 

 

 

3.  The EZ CAT Module can mount on or near the firewall.  Adhere the module 

using the supplied velcro. 

4.  Recheck all connections, fittings and fasteners for a properly secure 

installation. 

5.  Using the supplied wire ties, secure the wiring harness from possible damage. 

 

 

The installation of the brass elbow permits the turbo boost pressure to increase 
without the wastegate opening.  The Power Edge EZ CAT Module will operate 
equally well with or without this installed. 
 
6.  Using the pliers, remove the crimp style clamp from the hose on the stock brass 

elbow located on the bottom side of the turbocharger.  Remove the hose from 
the brass elbow and dispose of the crimp style clamp. 

 

Boost Sensor

IAP Sensor Connectors