EDGE Tech B & E ユーザーズマニュアル
8
7. Using the 7/16” wrench, unscrew the stock brass elbow out of the turbocharger
housing. Using the 7/16” wrench, install the supplied brass elbow, tighten-be
careful not to over-tighten. Slip the supplied hose clamp onto the stock hose,
install the stock hose onto the newly installed brass elbow and tighten the hose
clamp with the ¼” socket.
careful not to over-tighten. Slip the supplied hose clamp onto the stock hose,
install the stock hose onto the newly installed brass elbow and tighten the hose
clamp with the ¼” socket.
Fueling Adjustment
The Power Edge EZ CAT Module features 4 different levels of fueling. The Module
is set default to level 2.
1. To change settings remove the front panel by using a 3/32” allen wrench to
is set default to level 2.
1. To change settings remove the front panel by using a 3/32” allen wrench to
remove the two screws.
2. Below the cover the 3 jumper settings on the right side are used for the power
level adjustment.
3. The two jumpers can be repositioned in any of the locations shown below to
achieve the desired response.
Power Gains
The following power gains are representative of an actual test vehicle. Power gains
may vary somewhat on a different vehicle or in different geographic settings.
may vary somewhat on a different vehicle or in different geographic settings.
Level 1:
25 HP
Level 2:
30 HP
Level 3:
35 HP
Level 4:
40 HP
EZ PC Board
Jumpers
Power Level 1
EZ PC Board
Jumpers
Power Level 2
EZ PC Board
Jumpers
Power Level 3
EZ PC Board
Jumpers
Power Level 4