Tascam US-1800 ユーザーズマニュアル

0

Use the included USB cable to connect the unit to a 

computer.
(Only compatible with USB 2.0.)

q

This coaxial digital input jack is compatible with the 

IEC60958-3 (S/PDIF) standard. 

w

This coaxial digital output jack is compatible with 

the IEC60958-3 (S/PDIF) and AES3-2003 (AES/EBU) 

standards. This jack outputs the same signals as 

 

 or 

. Set this using the 

control panel. The digital signal format can also be set 

using the control panel. 

signals at 24-bit/96 kHz. 
e

This standard 5-pin DIN connector can be used to 

output MIDI signals. 

r

This standard 5-pin DIN connector can be used to 

input MIDI signals. 

t

 (

) are standard TRS balanced input jacks. 

Use the 

 switches to set the nominal level to either 

–10 dBV (

) or +4 dBu (

). 

y

These standard TRS jacks are balanced analog line 

output jacks. The nominal output level is +4 dBu. These 

jacks output signals sent from a computer to the unit 

by USB. Use the audio application on the computer to 

set which signals to output. Connect these outputs to 

an external mixer, recorder or other device.
(Tip: HOT, Ring: COLD, Sleeve: GND)

u

These standard TRS jacks are balanced analog jacks 

that output the monitoring signals. These can output 

both a mono mix of signals from the unit inputs 

(

) and the signals output from the computer for 

monitoring. Use the 

 knob on the front panel 

to adjust the balance of these two sources. Use the 

 knob on the front panel to adjust the output 

level. 
Connect these jacks to monitor speakers, for example.
(Tip: HOT, Ring: COLD, Sleeve: GND)

i

Loop the cord of the included TASCAM PS-1225L 

AC adaptor here to prevent the plug from being 

disconnected accidentally.

o

Connect the included TASCAM PS-1225L AC adaptor 

to this Jack.