Netgear WMS105-10000S ユーザーズマニュアル

On the Configuration tab, select Access Point Discovery, and then click the IP Discovery 
tab:

To specify the range of IP addresses, fill in the Start IP and End IP fields.

Click Search. 

The Wireless Management Software locates devices on the LAN within the range of 

IP addresses that you specified.

The devices are displayed in a list.

Check the discovery results to make sure that all the access points are listed. See 

Discovery Results

The effectiveness of the discovery feature depends in part on how the access points on your 
LAN are set up. If each access point is configured with a unique IP address and is running 
current firmware, then discovery is usually simple. 

If the discovery results are not what you expect, check the following:

Access points already managed by the Wireless Management Software will not be shown 

in the discovery list.

If two or more access points still have their factory default settings, their IP addresses 

might be identical. If this is the case, the Wireless Management Software discovers one 
of these access points. Add that access point, change its IP address, and then use 
discovery to find the next access point.

If discovery results show unknown access points, it could be due to these reasons:

The access point is running an older version of firmware. Upgrade firmware as 
needed so that discovery can locate the access point.

The Wireless Management Software located a NETGEAR access point that is not 
supported or located a NETGEAR device that is not an access point.