Netgear WMS105-10000S ユーザーズマニュアル

Trap Port: The default port on which SNMP manager receives traps sent from the 

Wireless Management Software is 162.

SNMP Manager IP: Restrict access to specified SNMP manager for doing SNMP v1/v2. 

Set this as 255.255.255.255 to allow any SNMP manager to access.

When you are finished making changes, click Apply to save your settings.

Remote Management

You can enable SSH or Telnet to remotely log in to the controller. From the Maintenance tab 
select Remote Management > System > Remote Console:

Select the radio button for SSH or Telnet:

Secure Shell (SSH): If set to Enable, the Wireless Management Software allows 

remote access by using Secure Shell.

Telnet: If set to Enable, the Wireless Management Software allows remote access by 

using Telnet.

Click Apply to save your settings.

Upgrading Access Point Firmware

You can install a new firmware for the access points using the Access Point Upgrade page.

See the Release Notes included with the software to find out if you need to reconfigure the 
access point. Reconfiguring access points already managed by the Wireless Management 
Software requires only the IP address to be set manually. The Wireless Management 
Software restores configuration for already managed access points running supported 
software version.