Aleratec 350108 ユーザーズマニュアル

www.aleratec.com

14

Main Menu: Copy HDD

The “Copy HDD” function performs an actual copy from the source HDD to the target 

HDD. The target HDD must be at least as large as the source. The HDD PortaCruiser 

will copy every block of capacity on the source HDD. 

Load the source HDD and the target HDD into the HDD PortaCruiser. The system 

1. 

will auto-detect the hard drives. After the drives have been detected, a screen 

similar to the one below will be displayed. 

Note: Before copying be sure that the capacity of the target HDD is equal to or 
larger than the source hard drive. 

Press 

2. 

ENT to start copying. The system will auto-detect the hard drives. The 

following information will be displayed. 

During the copy process the HDD PortaCruiser will display progress information.

3. 

The amount of data remaining to be transferred (shown in gigabytes), and time 

will be displayed in decreasing increments as the percentage of completion 

increases. 

Note: The copying speed, capacity and duration may vary from one source hard 
drive to another. 

Once duplication is complete, a job status screen will be displayed.

4. 















