AMCC 720-0138-00 ユーザーズマニュアル

Error and Notification Messages

117

Error and Notification Message Details

The 3ware RAID controller has detected a soft reset from the device driver. If 
the 3ware RAID controller fails to respond to the device driver within a 
reasonable amount of time, the device driver may issue a soft reset to the 
3ware RAID controller and retry the command packet. For more information, 
see 

http://www.3ware.com/KB/article.aspx?id=14923.

An error has been encountered and the unit is operating in degraded (non-
redundant) mode. You should replace the bad drive as soon as possible and 
initiate a rebuild.

Removing a drive from a redundant unit will cause this message to display 
immediately.

The 3ware RAID controller has encountered an internal error. Please contact 
AMCC Customer Support as a replacement board may be required. 

The 3ware RAID controller was unable to complete a rebuild operation. This 
error can be caused by drive errors on either the source or the destination of 
the rebuild. However, due to ATA drives’ ability to reallocate sectors on write 
errors, the rebuild failure is most likely caused by the source drive of the 
rebuild detecting some sort of read error. The default operation of the 3ware 
RAID controller is to abort a rebuild if an error is encountered. If it is desired 
to continue on error, you can set the Continue on Source Error During Rebuild 
policy for the unit on the Controller Settings page in 3DM.

 For more information, see “Setting Continue on Source Error During 
Rebuild” on page 47.

The 3ware RAID controller has successfully completed a rebuild. The 
completion of the rebuild changes the state of the unit from rebuilding to OK. 
The data is now redundant.