AMCC 720-0138-00 ユーザーズマニュアル

Chapter 3. 3DM 2 (3ware Disk Manager) Introduction

24

Setting Up 3DM Preferences

The 3DM 2 Settings page lets you define preference settings that affect the 
overall operation of 3DM. Most of these settings are specified initially during 
installation of 3DM.

On the 3DM 2 Settings page you can perform the following tasks:
•

Lets you configure new units and make changes to 
existing units.

To view this page, choose Management > Maintenance 
from the menu bar.

Shows a list of alarms, including the specific alarm 
message, and the exact date and time it occurred.

To view this page, choose Monitor > Alarms on the menu 
bar.

Shows the status of a Battery Backup Unit (BBU), if one is 
installed, and allows you to test the battery.

To view this page, choose Monitor > Battery Backup on 
the menu bar.

(BBUs are not supported on the 9590SE-4ME.)

Lists the enclosures attached to your 3ware controller.

To view this page, choose 

 on the menu bar.

Shows details about a particular enclosure, including 
status information. You can also use this page to blink the 
LED for a particular drive. 

To view this page, click the ID number of the Enclosure on 
the Enclosure Summary page. 

Lets you set preferences, including email notification for 
alarms, passwords, page refresh frequency, whether 
remote access is permitted, and the incoming port which 
3DM will use for listening.

To view this page, click 3DM 2 Settings on the menu bar.