Fujitsu PDS4203W-H / PDS4203E-H ユーザーズマニュアル

• The power does not come on.

• Is the power cord disconnected?

• The picture dose not appear.

• Is a cable to other equipment disconnected?

• The remote controller does not work.

• Are the batteries installed with their poles reversed?

• Are the batteries flat?

• Are you operating from far away?

• Are you trying to operate with the transmitting section of the

remote controller not facing the reception section of the

display?

• Is there any obstruction between the display and the remote

controller?

• There is a creaking sound.

• This sound is generated by the expansion and contraction of

the cabinet owing to change in the room temperature.

• There is a humming sound.

• The Plasmavision has heat radiation fins to prevent its internal

temperature from rising too high during operation. The sound

you hear is the fan rotating.

• There are dots on the screen.

• Is the connected tuner being affected by interference from a

car, train, high-voltage line, neon light, or the like?

• The colors and tints are not good.

• Do any of the video settings need readjusting?

• There is no sound.

• Are the internal speakers switched off?

• ERROR MESSAGE CONDITION 1 is displayed.

• The fan is malfunctioning.   Switch off the power.

• ERROR MESSAGE CONDITION 2 is displayed.

• The temperature inside the set has risen far too high.

Switch off the power.  (The power can be turned on once the

temperature lowers.)

Do not use benzene, paint thinner, or other solvents. They

can cause deterioration or paint peeling on the cabinet,

the screen front filter, or the remote controller.

Wipe gently with a soft cloth.

For stubborn grime, soak the soft cloth in neutral cleaning

agent diluted with water, wring it out well, and wipe clean.

Then, finish with a dry, soft cloth.

Wipe gently with a soft cloth.

The surface of the screen is easily scratched, so do not

strike it or rub it with anything hard.