Fujitsu TE988G ユーザーズマニュアル

 

 

 

 

If you are experiencing difficulties with your monitor, check following table for possible 

solutions. 

 

? No picture 

1. The VGA card should be completely seated in the slot. 

2. Power switch of the monitor and the PC should be in the ON 

position. 

3. The signal cable should be completely connected to the video 

card / computer. 

4. Check if the pins of the connector are twisted or shrunk.     

? Image is scrolling or 

unstable 

1. The signal cable should be completely connected to the 

computer.  

2. Check the pin assignments and signal timings of the monitor 

and your video card. 

? LED on the monitor is 

not lit   

1. Power switch should be in the ON position and the power cord 

should be connected.   

2. Check if the system is in the power saving mode. ( Check by 

pressing any one of keys on the keyboard or moving the 

mouse.)  

? Picture is fuzzy 

1. Adjust the Contrast and Brightness Controls.   

? Picture bounces or wave 

pattern is present in the 

picture 

1.. Move electrical devices that may be causing electrical 

interference away from the monitor. 

2. Refer to the FCC information of this manual.   

? Edges of the display 

image are cured either 

inward or outward 

1. Adjust the geometry control to adjust the display image. 

2. Locate the monitor facing to east.   

? Display image is not 

centered, too small, or 

too large 

1. Adjust the image using Size and Position Controls in the OSD.