Motorola MVME162 ユーザーズマニュアル
Functional Description
MVME162IG/D2
1-13
1
C
aution
For proper operation of the SRAM, some jumper
combination must be installed on the Backup Power Source
Select Header (J20). If one of the jumpers is used to select
the battery, the battery must be installed on the MVME162.
The SRAM may malfunction if inputs to the DS1210S are
left unconnected.
combination must be installed on the Backup Power Source
Select Header (J20). If one of the jumpers is used to select
the battery, the battery must be installed on the MVME162.
The SRAM may malfunction if inputs to the DS1210S are
left unconnected.
The SRAM is controlled by the MCchip, and the access time is programmable.
Refer to the MCchip description in the MVME162 Embedded Controller
Programmer’s Reference Guide for more detail.
Refer to the MCchip description in the MVME162 Embedded Controller
Programmer’s Reference Guide for more detail.
About the Battery
The power source for the onboard SRAM is a RAYOVAC FB1225 battery with
two BR1225 type lithium cells which is socketed for easy removal and
replacement. A small capacitor is provided to allow the battery to be quickly
replaced without data loss.
two BR1225 type lithium cells which is socketed for easy removal and
replacement. A small capacitor is provided to allow the battery to be quickly
replaced without data loss.
The lifetime of the battery is very dependent on the ambient temperature of the
board and the power-on duty cycle. The lithium battery supplied on the
MVME162 should provide at least two years of backup time with the board
powered off and with an ambient temperature of 40° C. If the power-on duty
cycle is 50% (the board is powered on half of the time), the battery lifetime is
four years. At lower ambient temperatures the backup time is greatly
extended and may approach the shelf life of the battery.
board and the power-on duty cycle. The lithium battery supplied on the
MVME162 should provide at least two years of backup time with the board
powered off and with an ambient temperature of 40° C. If the power-on duty
cycle is 50% (the board is powered on half of the time), the battery lifetime is
four years. At lower ambient temperatures the backup time is greatly
extended and may approach the shelf life of the battery.
When a board is stored, the battery should be disconnected to prolong battery
life. This is especially important at high ambient temperatures. The MVME162
is shipped with the batteries disconnected (i.e., with VMEbus +5V standby
voltage selected as both primary and secondary power source). If you intend
to use the battery as a power source, whether primary or secondary, it is
necessary to reconfigure the jumpers on J20 before installing the module. Refer
to SRAM Backup Power Source Select Header J20 in Chapter 2 for available
jumper configurations.
life. This is especially important at high ambient temperatures. The MVME162
is shipped with the batteries disconnected (i.e., with VMEbus +5V standby
voltage selected as both primary and secondary power source). If you intend
to use the battery as a power source, whether primary or secondary, it is
necessary to reconfigure the jumpers on J20 before installing the module. Refer
to SRAM Backup Power Source Select Header J20 in Chapter 2 for available
jumper configurations.
The power leads from the battery are exposed on the solder side of the board,
therefore the board should not be placed on a conductive surface or stored in
a conductive bag unless the battery is removed.
therefore the board should not be placed on a conductive surface or stored in
a conductive bag unless the battery is removed.