National Instruments NI sbRIO-960x ユーザーズマニュアル

•

One stop bit

•

No flow control

Keep this switch in the OFF position during normal operation. If 
CONSOLE OUT is enabled, LabVIEW RT cannot communicate with the 
serial port.

Push the IP RESET switch to the ON position and reboot the sbRIO device 
to reset the IP address to 

0.0.0.0

. If the device is on your local subnet and 

the IP RESET switch is in the ON position, the device appears in MAX 
with IP address 

0.0.0.0

. You can configure a new IP address for the 

device in MAX. Refer to the 

 section for more information about resetting the IP address. 

Push the NO APP switch to the ON position to prevent a LabVIEW RT 
startup application from running at startup. If you want to permanently 
disable a LabVIEW RT application from running at startup, you must 
disable it in LabVIEW. To run an application at startup, push the NO APP 
switch to the OFF position, create an application using the LabVIEW 
Application Builder, and configure the application in LabVIEW to launch 
at startup. For more information about automatically launching VIs at 
startup and disabling VIs from launching at startup, refer to the Running a 
Stand-Alone Real-Time Application (RT Module) topic of the LabVIEW 
Help.

You can define the USER1 switch for your application. To define the 
purpose of this switch in your embedded application, use the RT Read 
Switch VI in your LabVIEW RT embedded VI. For more information 
about the RT Read Switch VI, refer to the LabVIEW Help.

Push the NO FPGA switch to the ON position to prevent a LabVIEW 
FPGA application from loading at startup. The NO FPGA switch overrides 
the options described in the 

 section. After startup you can 

download bit files to flash memory from a LabVIEW project regardless of 
switch position. If you already have an application configured to launch at 
startup and you push the NO FPGA switch from ON to OFF, the startup 
application is automatically enabled.