National Instruments 1142 ユーザーズマニュアル
Chapter 2
Connecting Signals
2-12
ni.com
The digital output signal is pin 26. Pin 26 is SER DAT OUT and is
equivalent to the SCXIbus MISO serial data output line.
equivalent to the SCXIbus MISO serial data output line.
The digital I/O signals of the SCXI-1141/1142/1143 module correspond
to the digital I/O lines of an E/M Series DAQ device. Table 2-4 lists the
equivalencies.
to the digital I/O lines of an E/M Series DAQ device. Table 2-4 lists the
equivalencies.
The digital timing signals are pins 36 and 43:
•
Pin 36 is SCAN CLK, the signal used as a clock for the
SCXI-1141/1142/1143 module multiplexer counter. The DAQ device
pulses this signal at the end of each conversion if the module is in
multiplexed mode.
SCXI-1141/1142/1143 module multiplexer counter. The DAQ device
pulses this signal at the end of each conversion if the module is in
multiplexed mode.
•
Pin 43 is a reserved digital input.
Table 2-4. SCXIbus to SCXI-1141/1142/1143 Module Rear Signal Connector
to DAQ Device Pin Equivalencies
SCXIbus Line
SCXI-1141/1142/1143
Rear Signal Connector
E/M Series
DAQ Device
MOSI
SER DAT IN
DIO0
D*/A
DAQ D*/A
DIO1
INTR*
SLOT 0 SEL*
DIO2
SPI CLK
SER CLK
EXT STROBE*
MISO
SER DAT OUT
DIO4
Note: An * means the signal is asserted low.