Cypress CY8C20x46 ユーザーズマニュアル
CY8C20x36/46/66, CY8C20396
Document Number: 001-12696 Rev. *D
Page 31 of 34
Accessories (Emulation and Programming)
Third-Party Tools
Several tools have been specially designed by the following
third-party vendors to accompany PSoC devices during
development and production. Specific details for each of these
tools can be found at
third-party vendors to accompany PSoC devices during
development and production. Specific details for each of these
tools can be found at
under
Documentation >> Evaluation Boards.
Build a PSoC Emulator into Your Board
For details on how to emulate your circuit before going to volume
production using an on-chip debug (OCD) non-production PSoC
device, refer Application Note “Debugging - Build a PSoC
Emulator into Your Board - AN2323” at
production using an on-chip debug (OCD) non-production PSoC
device, refer Application Note “Debugging - Build a PSoC
Emulator into Your Board - AN2323” at
http://www.cypress.com/
AN2323
.
Table 35. Emulation and Programming Accessories
Part Number
Pin Package
Flex-Pod Kit
[14]
Foot Kit
Adapter
CY8C20236-24LKXI
16 QFN
CY3250-20266QFN
CY3250-16QFN-RK
See note 15
CY8C20336-24LQXI
24 QFN
CY3250-20366QFN
CY3250-20366QFN
See note 15
CY8C20436-24LQXI
32 QFN
CY3250-20466QFN
CY3250-32QFN-RK
See note 15
CY8C20396-24LQXI
Not Available
CY8C20246-24LKXI
16 QFN
CY3250-20266QFN
CY3250-16QFN-FK
CY8C20346-24LQXI
24 QFN
CY3250-20366QFN
CY3250-24QFN-FK
CY8C20446-24LQXI
32 QFN
CY3250-20466QFN
CY3250-32QFN-FK
CY8C20466-24LQXI
32 QFN
CY3250-20466QFN
CY3250-32QFN-FK
CY8C20566-24PVXI
48 SSOP
CY3250-20X66
CY3250-48SSOP-FK
CY8C20666-24LTXI
48 QFN
CY3250-20666QFN
CY3250-48QFN-FK
Notes
14. Flex-Pod kit includes a practice flex-pod and a practice PCB, in addition to two flex-pods.
15. Foot kit includes surface mount feet that can be soldered to the target PCB.
16. Programming adapter converts non-DIP package to DIP footprint. Specific details and ordering information for each of the adapters can be found at
15. Foot kit includes surface mount feet that can be soldered to the target PCB.
16. Programming adapter converts non-DIP package to DIP footprint. Specific details and ordering information for each of the adapters can be found at