IBM XSERIES 220 ユーザーズマニュアル
Diagnostics
19
Replacing the battery
When replacing the battery you must replace it with a lithium battery of the same
type, from the same manufacturer. To avoid possible danger read and follow the
safety statement below.
type, from the same manufacturer. To avoid possible danger read and follow the
safety statement below.
To order replacement batteries, call 1-800-772-2227 within the United States, and
1-800-465-7999 or 1-800-465-6666 within Canada. Outside the U.S. and Canada, call
your IBM reseller or IBM marketing representative.
1-800-465-7999 or 1-800-465-6666 within Canada. Outside the U.S. and Canada, call
your IBM reseller or IBM marketing representative.
Note:
After you replace the battery, you must reconfigure the server and reset the
system date and time.
system date and time.
CAUTION:
When replacing the battery, use only IBM Part Number 33F8354 or an equivalent
type battery recommended by the manufacturer. If your system has a module
containing a lithium battery, replace it only with the same module type made by
the same manufacturer. The battery contains lithium and can explode if not
properly used, handled, or disposed of.
When replacing the battery, use only IBM Part Number 33F8354 or an equivalent
type battery recommended by the manufacturer. If your system has a module
containing a lithium battery, replace it only with the same module type made by
the same manufacturer. The battery contains lithium and can explode if not
properly used, handled, or disposed of.
Do not:
•
Throw or immerse into water
•
Heat to more than 100
°
C (212
°
F)
•
Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
Do the following to replace the battery:
1.
Read “Before you begin” on page 58, and follow any special handling and
installation instructions supplied with the replacement battery.
installation instructions supplied with the replacement battery.
2.
Turn off the server and peripheral devices and disconnect all external cables and
power cords; then, remove the server cover.
power cords; then, remove the server cover.
3.
Remove any PCI cards that might impede access to the battery.
4.
Remove the battery:
a.
Use one finger to lift the battery clip over the battery.
b.
Use one finger to slightly slide the battery out from its socket. The spring
mechanism will push the battery out toward you as you slide it from the
socket.
mechanism will push the battery out toward you as you slide it from the
socket.
c.
Use your thumb and index finger to pull the battery from under the battery
clip.
clip.
On
System error (front panel)
The diagnostic LEDs have detected a
system error.
system error.
Off
None
The diagnostic LEDs have not
detected a system error.
detected a system error.
System Error LED (on the front panel)
System board LED
Cause
Table 2. Diagnostic LEDs.